Key Features

• 32bit ARM Cortex-M0 based evaluation board for W5500 chip
• Hardware pin-compatible with Arduino Uno Rev.3 shield
• On-board temperature sensor / potentiometer (provide reference code)
• 2 Push button switch (SW), 1 x RGB LED, 4-Mbit external data flash memory
• Ethernet / USB-mini B connector and 10-pin Cortex debug connector for SWD (Serial Wire Debug)
• Provides various application code – Loopback, DHCP, DNS, Controlling on-board sensor & potentiometer

Hardware Specification

• MCU : NXP Cortex-M0 (Running at up to 50MHz, 96KB Flash, 2KB SRAM, 4KB EEPROM)
• Ethernet : W5500(WIZnet Hardwired TCP/IP)
• IO : 16 GPIOs, 6 Pins Analog Peripheral using 10bit ADC
• RJ-45 :  10/100 Base-TX RJ-45 with Transformer (J1B1211CCD / CETUS)
• USB : USB Mini-B (On-board USB-to-UART IC, USB BUS Power / FT232RL)
• Power : 5V DC Power
• On-board User I/F : 2xPush button switch, 1xRGB LED, Temperature Sensor, Potentiometer
• External Memory : 4-Mbit Serial Data Flash Memory (AT45DB041D-SU)
• Dimension (mm) : 93 (L) x 53 (W) x 17.3(H)

Firmware

Getting start

Make New Project